BS EN 14870-1. Petroleum and natural gas industries. Induction bends, fittings and flanges for pipeline transportation systems Part 1. Induction bends
|Standard number:||21/30437402 DC|
|Status:||Draft for Comment|
This standard 21/30437402 DC BS EN 14870-1. Petroleum and natural gas industries. Induction bends, fittings and flanges for pipeline transportation systems is classified in these ICS categories:
- 75.200 Petroleum products and natural gas handling equipment
- 23.040.60 Flanges, couplings and joints
- 23.040.40 Metal fittings
This document specifies the technical delivery conditions for bends made by the induction bending process for use in pipeline transportation systems for the petroleum and natural gas industries as defined in ISO 13623 .
ISO 13623 is modified adopted as EN 14161 to exclude on-land supply systems used by the European gas supply industry from the input of gas into the on-land transmission network up to the inlet connection of gas appliances.
This document is applicable to induction bends made from seamless and welded pipe of unalloyed or low-alloy steels.
These are typically C-Mn steels or low-alloy steels that are appropriate for the corresponding level and grade of line pipe in accordance with ISO 3183 .
This document specifies the requirements for the manufacture of two product specification levels (PSLs) of induction bends corresponding to product specification levels given for pipe in ISO 3183 .
This document is not applicable to the selection of the induction bend PSL. It is the responsibility of the purchaser to specify the PSL, based upon the intended use and design requirements; see also ISO 3183 , Introduction.
This document is not applicable to pipeline bends made by other manufacturing processes.
On-land supply systems used by the European gas supply industry from the input of gas into the on-land transmission network up to the inlet connection of gas appliances are excluded from the scope of this document.