ASTM A0770_A0770M-03R18
Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications
| Language: | English |
| Released: | 2018-09-19 |
| Pages: | 5 |
| Standards number: | ASTM A0770_A0770M-03R18 |
| Standard number: | A0770_A0770M-03R18 |
| Released: | 01.09.2018 |
| Status: | Active |
| Pages: | 5 |
| Section: | 01.04 |
| Keywords: | lamellar tearing; special steel-making processes; steel plate; through-thickness tension testing; |
1.1 This specification2 covers the procedures and acceptance standards for the determination of reduction of area using a tension test specimen whose axis is perpendicular to the rolled surfaces of steel plates 1 in. [25 mm] and greater in thickness. The principal purpose of the testing is to provide a measure of the resistance of a steel plate to lamellar tearing. (See Appendix X1.)
1.2 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 This specification is expressed in both inch-pound and SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.