ASTM A0960_A0960M-24A - Standard Specification for Common Requirements for Wrought Steel Piping Fittings
Standard Specification for Common Requirements for Wrought Steel Piping Fittings
Standard number: | A0960_A0960M-24A |
Released: | 15.08.2024 |
Status: | Active |
Pages: | 11 |
Section: | 01.01 |
Keywords: | austenitic stainless steel; corrosive service applications; ferritic/austenitic stainless steel; ferritic stainless steel; high strength low alloy steel; martensitic stainless steel; piping applications; pressure containing parts; pressure vessel service; stainless steel fittings; temperature service applications-elevated; temperature service applications-low; temperature service applications-moderate ; |
1.1 This specification covers a group of common requirements that shall apply to wrought steel piping fittings covered in any of the following individual product specifications or any other ASTM specification that invokes this specification or portions thereof:
Title of Specification | ASTM |
Specification for Piping Fittings of Wrought | A234/A234M |
Specification for Wrought Austenitic Stainless | A403/A403M |
Specification for Piping Fittings of Wrought Carbon | A420/A420M |
Specification for Wrought-Carbon Steel Butt-Welding | A758/A758M |
Specification for As-Welded Wrought Austenitic | A774/A774M |
Specification for Wrought Ferritic, Ferritic/Austenitic, | A815/A815M |
Specification for Heat-Treated Carbon Steel | A858/A858M |
Specification for Wrought High-Strength | A860/A860M |
1.2 In case of conflict between a requirement of the individual product specification and a requirement of this general requirement specification, the requirements of the individual product specification shall prevail over those of this specification.
1.3 By mutual agreement between the purchaser and the supplier, additional requirements may be specified (See 4.1.8). The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon by the purchaser and supplier.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text and the tables, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification. The inch-pound units shall apply unless the “M” designation [SI] of the product specification is specified in the order.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.