PRICES include / exclude VAT
Homepage>ASTM Standards>ASTM B0183-18 - Standard Practice for Preparation of Low-Carbon Steel for Electroplating
Sponsored link
Not available online - contact us!
Released: 2018-06-05

ASTM B0183-18

Standard Practice for Preparation of Low-Carbon Steel for Electroplating

CURRENCY
57.07 USD
Language:English
Released:2018-06-05
Pages:3
Standards number:ASTM B0183-18
Standard number:B0183-18
Released:01.06.2018
Status:Active
Pages:3
Section:02.05
DESCRIPTION

1.1 This practice is intended as an aid to electroplaters in setting up a suitable cleaning cycle preparatory to electroplating of low-carbon steel (Note 1) containing less than 0.35 mass % of carbon and to indicate some of the precautions that must be taken to maintain this cycle in good operating condition.

Note 1: The preparation of high-carbon steel for electroplating is covered in Guide B242.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.