PRICES include / exclude VAT
Homepage>ASTM Standards>ASTM B0949-18 - Standard Specification for General Requirements for Zinc and Zinc Alloy Products
Sponsored link
Not available online - contact us!
Released: 2019-01-31

ASTM B0949-18

Standard Specification for General Requirements for Zinc and Zinc Alloy Products

CURRENCY
57.78 USD
Language:English
Released:2019-01-31
Pages:5
Standards number:ASTM B0949-18
Standard number:B0949-18
Released:01.11.2018
Status:Active
Pages:5
Section:02.04
Keywords:alloys; anode; block; casting; CGG; chemical analysis; chemical requirements; color code; hot-dip alloys ingot; jumbo; rolled zinc; wire; zinc; zinc alloy;
DESCRIPTION

1.1 This specification establishes general requirements, unless otherwise specified in the specific product specification, for ordering information, marking, and sampling for chemical analysis common to zinc and zinc alloy products and shall apply to Specifications B6, B69, B86, B240, B327, B418, B750, B792, B793, B833, B852, B860, B892, B894, B897, B907, B943, and B960 to the extent referenced therein.

1.2 Although this specification establishes general requirements, it does not restrict that, by agreement between customer and supplier, these requirements may be altered by a customer to suit individual need.

1.3 The chemical composition, physical and mechanical properties, and all other requirements not included in this specification shall be prescribed in the product specification.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. This applies except where SI units only are specified.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.