ASTM B1010_B1010M-19
Standard Specification for Copper-Clad Steel Electrical Conductor for Tracer Wire Applications
| Language: | English |
| Released: | 2019-10-10 |
| Pages: | 4 |
| Standards number: | ASTM B1010_B1010M-19 |
| Standard number: | B1010_B1010M-19 |
| Released: | 01.10.2019 |
| Status: | Active |
| Pages: | 4 |
| Section: | 02.03 |
| Keywords: | annealed copper-clad steel wire; center conductor locating wire; center conductor tracer wire; clad steel electrical conductor; copper electrical conductor—copper-clad steel; copper-clad steel electrical conductor; electrical conductor; hard drawn copper-clad steel wire; locate wire; locating wire; steel wire—copper-clad; trace wire; tracer wire; |
1.1 This specification covers bare round 21 % conductivity copper-clad steel wire for the center conductor in tracer wire, also known as locating wire.
1.2 Two grades of copper-clad steel wire are covered as follows:
1.2.1 21EHS: Nominal 21 % Conductivity Extra High Strength
1.2.2 21EHS-A: Nominal 21 % Conductivity Extra High Strength-Annealed
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.