ASTM D5662-19A
Standard Test Method for Determining Automotive Gear Oil Compatibility with Typical Oil Seal Elastomers
| Language: | English |
| Released: | 2019-11-13 |
| Pages: | 7 |
| Standards number: | ASTM D5662-19A |
| Standard number: | D5662-19A |
| Released: | 01.11.2019 |
| Status: | Active |
| Pages: | 7 |
| Section: | 05.02 |
| Keywords: | compatibility; elastomer; elongation change; gear oil; hardness change points; oil seal; volume change; |
1.1 This test method2 covers the determination of the compatibility of automotive gear oils with specific nitrile, polyacrylate, and fluoroelastomer oil seal materials.
1.2 Users of this test method should obtain Test Methods D412, D471, and D2240 and become familiar with their use before proceeding with this test method.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.