PRICES include / exclude VAT
Homepage>ASTM Standards>ASTM D6485-18 - Standard Guide for Risk Characterization of Acute and Irritant Effects of Short-Term Exposure to Volatile Organic Chemicals Emitted from Bedding Sets
Sponsored link
Not available online - contact us!
Released: 2018-07-24

ASTM D6485-18

Standard Guide for Risk Characterization of Acute and Irritant Effects of Short-Term Exposure to Volatile Organic Chemicals Emitted from Bedding Sets

CURRENCY
57.78 USD
Language:English
Released:2018-07-24
Pages:7
Standards number:ASTM D6485-18
Standard number:D6485-18
Released:15.04.2018
Status:Active
Pages:7
Section:11.07
Keywords:acute toxicity; air concentration; emissions; exposure assessment; hazard assessment; health effect; inhalation; irritant effect; odor characterization; odor threshold; risk characterization;
DESCRIPTION

1.1 This guide describes procedures for conducting risk characterization of exposure to volatile organic chemicals (VOCs) emitted from bedding sets or an ensemble of a mattress and supporting box spring.

1.2 This guide is for risk characterization of short-term exposures to a new bedding set brought into a residential indoor environment. The risk characterization considerations presented in this guide are applicable to both the general population and sensitive subgroups, such as convalescing adults.

1.3 The risk characterization addressed in this guide is limited to acute health and irritation effects resulting from short-term exposure to VOCs in indoor air. Although certain procedures described in this guide may be applicable to assessing long-term exposure, the guide is not intended to address cancer and other chronic health effects.

1.4 VOC emissions from bedding sets, as in the case of other household furnishings, usually are highest when the products are new. A used bedding set may also emit VOCs, either from the original materials or as a result of its use. The procedures presented in this guide also are applicable to used bedding sets.

1.5 Risk characterization procedures described in this guide should be carried out under the supervision of a qualified toxicologist or risk assessment specialist, or both.

1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.