ASTM E1155-20
Standard Test Method for Determining <emph type="ital">F<inf>F</inf></emph> Floor Flatness and <emph type="ital">F<inf>L</inf></emph> Floor Levelness Numbers
| Language: | English |
| Released: | 2020-08-31 |
| Pages: | 8 |
| Standards number: | ASTM E1155-20 |
| Standard number: | E1155-20 |
| Released: | 01.07.2020 |
| Status: | Active |
| Pages: | 8 |
| Section: | 04.11 |
| Keywords: | Ff; FF Flatness; Fl; FL Levelness; floor; floor profile; floor profilometer; F-Number; |
1.1 This test method covers a quantitative method of measuring floor surface profiles to obtain estimates of the floor's characteristic FF Flatness and FL Levelness Face Floor Profile Numbers (F-Numbers) using the inch-pound system of units.
Note 1: A complete metric companion to Test Method E1155 has been developed, Test Method E1155M; therefore, no metric equivalents are shown in this test method.
1.2 The text of this test method references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this test method.
1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.