PRICES include / exclude VAT
Homepage>ASTM Standards>75>75.180>75.180.01>ASTM F2204_F2204M-16 - Standard Guide for Describing Shoreline and Inland Response Techniques
Sponsored link
Not available online - contact us!
Released: 15.01.2016

ASTM F2204_F2204M-16 - Standard Guide for Describing Shoreline and Inland Response Techniques

Standard Guide for Describing Shoreline and Inland Response Techniques

CURRENCY
64.2 USD
Standard number:F2204_F2204M-16
Released:15.01.2016
Status:Active
Pages:10
Section:11.08
DESCRIPTION

1.1 This guide describes methods to clean and remediate stranded oil on marine and lake shorelines, on river banks and other inland water body shorelines, and terrestrial habitats. The primary goal of any countermeasure is to aid recovery while minimizing additional impact.

1.2 This guide describes 22 different tactics that are available for consideration. These options range from natural recovery to active physical or biochemical intervention.

1.3 The tactics listed might not be appropriate under all possible circumstances, and multiple countermeasures could be appropriate on the same shoreline, river bank, lake shore or terrestrial habitat.

1.4 This guide describes technical considerations for selecting appropriate response countermeasures or techniques.

1.5 Selection of specific countermeasures for use during a spill response is guided by properties of the oil, degree of oiling, site accessibility, geomorphology, substrate and vegetation type, mobility of available equipment, hydrologic (coastal and inland) and meteorological conditions, and the presence of sensitive natural and archeological resources. It is advisable to consult with appropriate regulatory authorities since certain response options may require government authorization or approval, or both.

1.6 This guide does not address response to submerged, sunken or buried oil.

1.7 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.