PRICES include / exclude VAT
Homepage>ASTM Standards>ASTM F3300-18 - Standard Test Method for Abrasion Resistance of Flexible Packaging Films Using a Reciprocating Weighted Stylus
Sponsored link
Not available online - contact us!
Released: 2018-03-30

ASTM F3300-18

Standard Test Method for Abrasion Resistance of Flexible Packaging Films Using a Reciprocating Weighted Stylus

CURRENCY
57.78 USD
Language:English
Released:2018-03-30
Pages:8
Standards number:ASTM F3300-18
Standard number:F3300-18
Released:15.02.2018
Status:Active
Pages:8
Section:15.10
Keywords:abraser; abrasion; abrasion resistance; flexible film; linear abrader; packaging; wear;
DESCRIPTION

1.1 This test method covers the determination of the abrasion resistance of flexible non-conductive films and packaging materials using a weighted stylus that wears completely through a film by oscillating or reciprocating back and forth along a linear path until an electrical circuit is completed shutting down the test.

1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.