PRICES include / exclude VAT
Homepage>BS Standards>23 FLUID SYSTEMS AND COMPONENTS FOR GENERAL USE>23.040 Pipeline components and pipelines>23.040.10 Iron and steel pipes>BS EN 10217-2:2019 - TC Tracked Changes. Welded steel tubes for pressure purposes. Technical delivery conditions Electric welded non-alloy and alloy steel tubes with specified elevated temperature properties
Sponsored link
immediate downloadReleased: 2020-02-28
BS EN 10217-2:2019 - TC Tracked Changes. Welded steel tubes for pressure purposes. Technical delivery conditions Electric welded non-alloy and alloy steel tubes with specified elevated temperature properties

BS EN 10217-2:2019 - TC

Tracked Changes. Welded steel tubes for pressure purposes. Technical delivery conditions Electric welded non-alloy and alloy steel tubes with specified elevated temperature properties

CURRENCY
LANGUAGE
English
Standard number:BS EN 10217-2:2019 - TC
Released:2020-02-28
ISBN:978-0-539-07074-3
Status:Tracked Changes
DESCRIPTION
This standard BS EN 10217-2:2019 - TC Tracked Changes. Welded steel tubes for pressure purposes. Technical delivery conditions is classified in these ICS categories:
  • 77.140.75 Steel pipes and tubes for specific use
  • 23.040.10 Iron and steel pipes
This document specifies the technical delivery conditions for two test categories of electric welded tubes of circular cross section, with specified elevated temperature properties, made from non-alloy quality steel or alloy special steel. NOTE 1 These tube grades are intended to support the essential requirements of EU Directive 2014/68/EU in respect of pressure equipment with specified elevated temperature properties, covered under all relevant Categories as set out in Article 13 of that Directive. NOTE 2 Once this standard is published in the Official Journal of the European Union (OJEU), presumption of conformity to the Essential Safety Requirements (ESR) of Directive 2014/68/EU is limited to the technical data for the materials in this standard and does not presume adequacy of the material for a specific item of pressure equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of a specific item of equipment to verify that the ESRs of the Pressure Equipment Directive are satisfied, needs to be done by the designer or manufacturer of the pressure equipment, taking also into account any subsequent processing procedures which may affect properties of the base materials.
This product includes: