PRICES include / exclude VAT
Homepage>BS Standards>73 MINING AND MINERALS>73.040 Coals>BS ISO 20904:2020 Hard coal. Sampling of slurries
Sponsored link
immediate downloadReleased: 2020-03-04
BS ISO 20904:2020 Hard coal. Sampling of slurries

BS ISO 20904:2020

Hard coal. Sampling of slurries

Format
Availability
Price and currency
English Secure PDF
Immediate download
317.20 USD
English Hardcopy
In stock
317.20 USD
Standard number:BS ISO 20904:2020
Pages:44
Released:2020-03-04
ISBN:978 0 580 99816 4
Status:Standard
DESCRIPTION

BS ISO 20904:2020


This standard BS ISO 20904:2020 Hard coal. Sampling of slurries is classified in these ICS categories:
  • 73.040 Coals

This document sets out the basic methods for sampling fine coal, coal rejects or tailings of nominal top size <4 mm that is mixed with water to form a slurry. At very high ratios of fine solids to water when the material assumes a soft plastic form, the mixture is correctly termed a paste. Sampling of pastes is not covered in this document.

The procedures described in this document primarily apply to sampling of coal that is transported in moving streams as a slurry. These streams can fall freely or be confined in pipes, launders, chutes, spirals or similar channels. Sampling of slurries in stationary situations, such as a settled or even a well-stirred slurry in a tank, holding vessel or dam, is not recommended and is not covered in this Document.

This document describes procedures that are designed to provide samples representative of the slurry solids and particle size distribution of the slurry under examination. After draining the slurry sample of fluid and measuring the fluid volume, damp samples of the contained solids in the slurry are available for drying (if required) and measurement of one or more characteristics in an unbiased manner and with a known degree of precision. The characteristics are measured by chemical analysis or physical testing or both.

The sampling methods described are applicable to slurries that require inspection to verify compliance with product specifications, determination of the value of a characteristic as a basis for settlement between trading partners or estimation of a set of average characteristics and variances that describes a system or procedure.

Provided flow rates are not too high, the reference method against which other sampling procedures are compared is one where the entire stream is diverted into a vessel for a specified time or volume interval. This method corresponds to the stopped-belt method described in ISO 13909-2.