ASTM D1002-10R19
Standard Test Method for Apparent Shear Strength of Single-Lap-Joint Adhesively Bonded Metal Specimens by Tension Loading (Metal-to-Metal)
| Language: | English |
| Released: | 2019-04-30 |
| Pages: | 6 |
| Standards number: | ASTM D1002-10R19 |
| Standard number: | D1002-10R19 |
| Released: | 01.04.2019 |
| Status: | Active |
| Pages: | 6 |
| Section: | 15.06 |
| Keywords: | adhesives; metal-to-metal; shear strength; single-lap joint; tension loading; |
1.1 This test method covers the determination of the apparent shear strengths of adhesives for bonding metals when tested on a standard single-lap-joint specimen and under specified conditions of preparation and test.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.