ASTM F2919_F2919M-12R18
Standard Specification for Welded Wire Mesh Fence Fabric (Metallic-Coated or Polymer Coated) with Variable Mesh Patterns or Meshes Greater than 6 in.<sup>2</sup > [3871 mm<sup>2</sup>] in Panels
| Language: | English |
| Released: | 2018-03-29 |
| Pages: | 7 |
| Standards number: | ASTM F2919_F2919M-12R18 |
| Standard number: | F2919_F2919M-12R18 |
| Released: | 01.03.2018 |
| Status: | Active |
| Pages: | 7 |
| Section: | 01.06 |
| Keywords: | galvanized before welding; galvanized after welding; organic polymer coatings.; steel; welded mesh sizes; welded wire mesh fence fabric ; zinc-5 % aluminum-mishmetal alloy coated before welding; zinc and polymer coated; |
1.1 This specification covers welded wire mesh fence fabric produced from steel wire or metallic-coated steel wire. The metallic-coated fabric may be polymer coated after fabrication.
1.2 Welded wire mesh fence fabric is produced in four types, based on the kind of coating, as described in Section 4.
1.3 This specification is applicable to orders in either inch-pound units or SI units. Values stated in either inch-pound or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values in the two systems are not exact equivalents; therefore, each system shall be used independent of the other, without combining values in any way.
1.4 This specification references notes and footnotes, which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this specification.
1.5 The following safety hazards caveat pertains only to the test methods portion, 13.4, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.