PRICES include / exclude VAT
Homepage>ASTM Standards>ASTM F2945-18 - Standard Specification for Polyamide 11 Gas Pressure Pipe, Tubing, and Fittings
Sponsored link
Released: 2018-11-13

ASTM F2945-18

Standard Specification for Polyamide 11 Gas Pressure Pipe, Tubing, and Fittings

Format
Availability
Price and currency
English PDF Redline
Immediate download
77.04 USD
PDF
Immediate download
64.20 USD
Hardcopy
In stock
64.20 USD
Language:English
Released:2018-11-13
Pages:15
Standards number:ASTM F2945-18
Standard number:F2945-18
Released:01.09.2018
Status:Active
Pages:15
Section:08.05
DESCRIPTION

1.1 This specification covers requirements and test methods for the characterization of polyamide 11 pipe, tubing, and fittings for use in fuel gas pipelines. The pipe and fittings covered by this specification are intended for use in the distribution and transmission of fuel gases.

1.1.1 This specification does not cover threaded pipe. Generic fusion guidelines are given in Appendix X1. Design considerations are discussed in Appendix X2. In-plant quality control programs are specified in Annex A1.

1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

Note 1: Heat fusion joining of PA11 pipe and fittings meeting the requirements of this standard is limited to PA11 pipe and fittings meeting the requirements of this standard. Heat Fusion joining of PA11 pipe and fittings meeting the requirements of this standard is not allowed to pipes and fittings made from any other thermoplastic materials (for example, PA12, PEs, PVCs, etc.).

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following is an index of the annexes and appendixes in this specification:

Annexes

Subject

Annex A1

In-Plant Quality Control for sizes up to 12 in.

Annex A2

PA-11 Butt Fusion Fittings

Appendixes

Subject

Appendix X1

Butt Fusion Guidelines for PA-11 Piping

Appendix X2

Design Consideration

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.