PRICES include / exclude VAT
Homepage>ASTM Standards>ASTM G0076-18 - Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets
Sponsored link
Released: 2018-11-13

ASTM G0076-18

Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets

Format
Availability
Price and currency
English PDF Redline
Immediate download
68.48 USD
PDF
Immediate download
57.78 USD
Hardcopy
In stock
57.78 USD
Language:English
Released:2018-11-13
Pages:6
Standards number:ASTM G0076-18
Standard number:G0076-18
Released:01.10.2018
Status:Active
Pages:6
Section:03.02
Keywords:erosion; erosion rate; gas jet; metal erosion; solid particle ;
DESCRIPTION

1.1 This test method covers the determination of material loss by gas-entrained solid particle impingement erosion with jetnozzle type erosion equipment. This test method may be used in the laboratory to measure the solid particle erosion of different materials and has been used as a screening test for ranking solid particle erosion rates of materials in simulated service environments (1, 2).2 Actual erosion service involves particle sizes, velocities, attack angles, environments, and so forth, that will vary over a wide range (3-5). Hence, any single laboratory test may not be sufficient to evaluate expected service performance. This test method describes one well characterized procedure for solid particle impingement erosion measurement for which interlaboratory test results are available.

1.2 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard (exceptions below).

1.2.1 Exceptions: Table 1 uses HRB hardness. Footnote 7 and 11.2 use abrasive grit designations.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.