ASTM B0162-26
Standard Specification for Nickel Plate, Sheet, and Strip
| Standard number: | ASTM B0162-26 |
| Released: | 01.02.2026 |
| Status: | Active |
| Pages: | 9 |
| Section: | 02.04 |
| Keywords: | plate; sheet; strip; N02200; N02201; |
| ASTM number: | ASTM B162 |
| Supersedes: | B0162-99R19 |
This specification covers rolled nickel (UNS N02200) and low-carbon nickel (UNS N02201) plate, sheet, and strip. The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur. The material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness. For deep drawing and spinning quality sheet and strip, the material shall conform to specified values for grain size and hardness properties. The material shall be uniform in quality and temper, smooth, commercially straight or flat, and free of injurious imperfections. Test methods (chemical analysis, mechanical test, grain size test) shall be performed in accordance to referenced ASTM documents itemized herein.
1.1Â This specification covers rolled nickel (UNS N02200) and low-carbon nickel (UNS N02201) plate, sheet, and strip.
1.2Â The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3Â This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4Â This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.