ASTM B0343-92AR20
Standard Practice for Preparation of Nickel for Electroplating with Nickel
| Standard number: | ASTM B0343-92AR20 |
| Released: | 01.11.2020 |
| Status: | Active |
| Pages: | 3 |
| Section: | 02.05 |
| ASTM number: | ASTM B343 |
| Supersedes: | B0343-92AR14 |
This practice summarizes well-known, generally practical methods for producing adherent electrodeposits of nickel on nickel. The types of nickel for which an overplate of nickel may be desired are dull nickel, semi-bright nickel, bright nickel, and nickel strike. The following cleaning treatments may be used for all conditions and types of electrodeposited nickel: degreasing and electrolytic alkaline cleaning. The procedures should be used for etching or activating the nickel surface are the following: anodic treatment in concentrated sulfuric acid; anodic etching in sulfuric acid; anodic etching in watts-type bath; acid-nickel chloride treatment; etching by acid immersion; electropolishing treatment; and cathodic treatment.
1.1 This practice summarizes well-known, generally practical methods for producing adherent electrodeposits of nickel on nickel.
1.2 Electrodeposits of nickel on nickel are produced, for example, to improve the performance of decorative coatings, to reclaim electroplated parts that are defective, and to resume nickel electroplating after interruptions in processing. Interruptions may be deliberate, for example, to machine the electrodeposit at an intermediate stage in the electrodeposition of thick nickel coatings. The interruptions may be unintentional, for example, resulting from equipment and power failures.
1.3 To ensure good adhesion of nickel to nickel, precautions should be taken to avoid biopolar effects during nickel electroplating. This is of particular importance in return-type automatic plating machines where one rack follows another rack closely. Bipolar effects can be avoided by making the racks cathodic while they are entering or leaving the nickel tank. Separate current control on entry and exit stations is desirable.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.