ASTM B0551_B0551M-12R21
Standard Specification for Zirconium and Zirconium Alloy Strip, Sheet, and Plate
| Standard number: | ASTM B0551_B0551M-12R21 |
| Released: | 01.11.2021 |
| Status: | Active |
| Pages: | 10 |
| Section: | 02.04 |
| Keywords: | plate; sheet; strip; zirconium; zirconium alloy; |
| ASTM number: | ASTM B551/B551M |
| Supersedes: | B0551_B0551M-12R17 |
This specification covers five grades of zirconium strip, sheet, and plate. These are low oxygen zirconium (Grade R60700), unalloyed zirconium (Grade R60702), zirconium-tin (Grade R60704), zirconium-niobium (Grade R60705), and zirconium-niobium (Grade R60706). The materials shall be made from ingots that are produced by vacuum or plasma arc melting, vacuum electron-beam melting, a combination of these three methods or other melting processes conventionally used for reactive metals. All processes to be done in furnaces usually used for reactive metals. The various mill products covered by this specification are formed with the conventional extrusion, forging, or rolling equipment normally found in primary ferrous and nonferrous plants. The strip, sheet, and plate shall be supplied in the recrystallized annealed condition unless otherwise specified in the purchase order. The materials shall be subjected to chemical analysis and tensile strength, yield strength, elongation, bend, and flatness tests.
1.1 This specification2 covers five grades of zirconium strip, sheet, and plate.
1.2 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.
1.3 The following precautionary caveat pertains only to the test method portions of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.