ASTM B0740-21
Standard Specification for Copper-Nickel-Tin Spinodal Alloy Strip
| Standard number: | ASTM B0740-21 |
| Released: | 01.10.2021 |
| Status: | Active |
| Pages: | 6 |
| Section: | 02.01 |
| Keywords: | age hardening; copper-nickel-tin; spinodal; strip; UNS C72650; UNS C72700; UNS C72900; |
| ASTM number: | ASTM B740 |
| Supersedes: | B0740-09R15 |
This specification establishes the requirements for copper-nickel-tin spinodal alloy strips with Copper Alloy UNS Nos. C72700, C72900, and C72650. Tempers are available as follows: TB00 (solution heat treated), TD01 to TD12 (solution heat treated and cold worked), TX00 or TS01 to TS12 (spinodal hardened), or TM00 to TM08 (mill hardened). Materials shall be prepared and tested accordingly to examine their conformance to mechanical (tensile and yield strength, elongation, ductility, and bend ratio), chemical composition, and grain size requirements. Retests shall be performed on any lot of material that fails to adhere to specified requirements due to inadequate heat treatment, or fails to meet bend test requirements.
1.1 This specification establishes requirements for copper-nickel-tin alloy strip for Copper Alloy UNS Nos. C72700, C72900, and C72650 in the following alloys:
| Copper Alloy UNS No. | Nominal Composition Weight % | ||
| Copper | Nickel | Tin | |
| C72700 | 85 | 9 | 6 |
| C72900 | 77 | 15 | 8 |
| C72650 | 87.5 | 7.5 | 5 |
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification.
1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.