ASTM B0964-23 - Standard Test Methods for Flow Rate of Metal Powders Using the Carney Funnel
Standard Test Methods for Flow Rate of Metal Powders Using the Carney Funnel
Standard number: | B0964-23 |
Released: | 01.02.2023 |
Status: | Active |
Pages: | 4 |
Section: | 02.05 |
Keywords: | Carney Hall; Hall; flow rate; metal powder flow; powder flow; |
1.1 These test methods cover the determination of a flow rate, by use of the Carney funnel, of metal powders and powder mixtures that do not readily flow through the Hall funnel of Test Method B213.
1.2 This is a non-destructive quantitative test performed in the laboratory.
1.3 With the exception of the values for density and the mass used to determine density, for which the use of gram per cubic centimetre (g/cm3) and gram (g) units is the longstanding industry practice, the values in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only, and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.