ASTM D0025-12R22
Standard Specification for Round Timber Piles
| Standard number: | ASTM D0025-12R22 |
| Released: | 01.08.2022 |
| Status: | Active |
| Pages: | 8 |
| Section: | 04.10 |
| Keywords: | piles; round timber piles; timber; |
| ASTM number: | ASTM D25 |
| Supersedes: | D0025-12R17 |
This specification deals with the standards for unused round timber piles to be used either treated or untreated. This specification, however, does not cover preused piles unless the piles have the quality and design stresses equal to or greater than those prescribed herein. The piles shall be made of sound wood, free of decay, insect attacks, marine borer attack, and Limnoria damage. The piles shall also be cut above the ground swell and have a tapered tip.
1.1 This specification covers the physical characteristics of unused round timber piles to be used either treated or untreated.
1.2 This specification is not intended for preused piles unless the piles have the quality specified by this specification and design stresses equal to or greater than those derived from Method D2899.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.