ASTM D5078_D5078M-11R21
Standard Specification for Crack Filler, Hot-Applied, for Asphalt Concrete and Portland Cement Concrete Pavements
| Standard number: | ASTM D5078_D5078M-11R21 |
| Released: | 01.05.2021 |
| Status: | Active |
| Pages: | 3 |
| Section: | 04.03 |
| Keywords: | asphalt concrete pavement; crack; hot-applied crack; portland cement concrete pavement; |
| ASTM number: | ASTM D5078/D5078M |
| Supersedes: | D5078_D5078M-11R16 |
This specification covers the standards for hot-applied crack filler proposed for use in filling cracks in asphalt concrete and portland cement concrete pavements. The filler shall be a compound that will effectively fill cracks in concretes and shall resist softening and pickup by vehicle tires at ambient summer temperatures. The fillers shall also comply with the requirements set for the safe heating temperature, softening point, cone penetration, resilience, and asphalt compatibility.
1.1 This specification covers hot-applied crack filler for use in filling cracks in asphalt concrete and portland cement concrete pavements.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.