ASTM D6763-16R22
Standard Guide for Testing Exterior Wood Stains and Clear Water Repellents
| Standard number: | ASTM D6763-16R22 |
| Released: | 01.12.2022 |
| Status: | Active |
| Pages: | 9 |
| Section: | 06.02 |
| Keywords: | clear water repellents; exterior wood stains; viscosity; |
| ASTM number: | ASTM D6763 |
| Supersedes: | D6763-16 |
This guide covers the selection and use of procedures for testing exterior wood stains. This includes both water borne and solvent borne semitransparent and opaque stains. The different conditions that affect coatings are presented in details. The balance of properties must be considered when establishing the requirements and selecting the tests. The different test methods in determining the liquid coating properties are enumerated and discussed. The different methods in determining the coating application and film formation are presented and discussed in details. The different test methods of determining the appearance of dry films are presented. The different test method of determining the dry coating properties are presented in details. The different test methods and practices in performing the chemical analysis of exterior woods are presented in details. Although many of the recommended test methods attempt to simulate conditions under which coatings are applied and used, it is not possible to duplicate accurately all possible conditions. Testing materials, including appropriate controls, under field conditions is recommended for the final evaluation of suitability.
1.1 This guide covers the selection and use of procedures for testing exterior wood stains and clear water repellents. This includes both water borne and solvent borne semitransparent and opaque stains and clear water repellents. The properties that can be examined or, in some cases, the relevant test procedures are listed in 2.1 and 2.2.
Note 1: The term “opaque stain” is defined as a pigmented composition intended for use on wooden surfaces to produce a uniform finish that obscures the grain and color of the wood, but not its surface texture; also called solid color or solid hide.
Note 2: The term “semitransparent” is defined as a pigmented composition intended for use on wooden surfaces to produce a uniform finish that does not fully obscure the grain or the texture of the wood.
Note 3: The term “clear” is defined as a transparent composition intended for use on wooden surfaces to produce a uniform finish that does not obscure the grain or texture of the wood.
1.1.1 Discussion—When applied to woods that differ in color, there is a color difference between stained substrates.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.