ASTM E0252-24
Standard Test Method for Thickness of Foil and Thin Sheet by Mass Measurement
| Standard number: | ASTM E0252-24 |
| Released: | 15.05.2024 |
| Status: | Active |
| Pages: | 5 |
| Section: | 02.02 |
| Keywords: | density; dimensions; foil; gauge; mass; measure; thickness; thin sheet; |
| ASTM number: | ASTM E252 |
| Supersedes: | E0252-06R21E01 |
This test method covers the standard procedures for the determination of the thickness of metallic foils, thin sheets, and films by measuring the mass of the specimen of known area and density. The apparatuses needed for this method are a precision blanking press for cutting specimens into circles of a specified area or diameter, and a balance for measuring its mass. The thickness shall then be calculated by using an equation that relates it with the specimen's mass, area, and density.
1.1 This test method covers the determination of the thickness of metallic foil and sheet 0.015 in. (0.38 mm) and less in thickness by measuring the mass of a specimen of known area and density.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.2.1 The density within this standard is provided in units of lb/in.3 (kg/m3) to be consistent with those listed in the “Aluminum Standards and Data” published by the Aluminum Association.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.