ASTM E3499-25
Standard Test Method for Indentation Plastometry of Metallic Materials
| Standard number: | ASTM E3499-25 |
| Released: | 01.10.2025 |
| Status: | Active |
| Pages: | 15 |
| Section: | 03.01 |
| Keywords: | indentation; inverse finite element analysis; mechanical test; metals; plastometry; tensile strength; yield strength; |
1.1 This test method covers procedures for carrying out indentation plastometry, an indentation-based test technique to determine the plastic stress-strain properties of metallic materials, including yield strength, tensile strength and uniform elongation at necking, using inverse finite element analysis.
1.2 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.