ASTM F0639-09R24
Standard Specification for Polyethylene Plastics for Medical Applications
| Standard number: | ASTM F0639-09R24 |
| Released: | 01.05.2024 |
| Status: | Active |
| Pages: | 4 |
| Section: | 13.01 |
| Keywords: | plastic surgical devices/applications; polyethylene (PE) plastics—surgical implant applications; polymers—surgical applications; |
| ASTM number: | ASTM F639 |
| Supersedes: | F0639-09R15 |
This specification covers the properties for polyethylene plastics for use in medical device applications involving human tissue contact devices, short term indwellings, and fluid transfer devices. Biocompatibility tests must be conducted on the final products as the biocompatibility of these materials as a class has not been established. Plyethylene plastics should consist of basic polymers with ethylene as essentially the sole monomer. The compound may contain optional adjuvant substances required in polymer production or fabrication. The final compound should yield a consistent absorption spectrum characteristic of the established formulation. The polyethylene plastics should be tested using the specified physical test procedures for density, melt flow, tensile properties, compressive properties, stiffness, flexural fatigue, and other flexural properties.
1.1 This specification covers polyethylene plastics (as defined in Terminology D883) intended for use in medical device applications involving human tissue contact devices, short-term indwellings of 30 days or less, and fluid transfer devices. The biocompatibility of these materials as a class has not been established. Biocompatibility tests must be conducted on the final product.
1.2 This specification is not applicable to ultra-high molecular weight polyethylene (UHMWPE) plastics, such as those used in joint implants, and so forth.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.