ASTM F1790_F1790M-15R25
Standard Test Method for Measuring Cut Resistance of Materials Used in Protective Clothing with CPP Test Equipment
| Standard number: | ASTM F1790_F1790M-15R25 |
| Released: | 01.06.2025 |
| Status: | Active |
| Pages: | 10 |
| Section: | 11.03 |
| Keywords: | cut protection; cut resistance; cut-through distance; protective clothing; calculated cutting load; |
| ASTM number: | ASTM F1790/F1790M |
| Supersedes: | F1790_F1790M-15R21 |
1.1 This test method covers the measurement of the cut resistance of a material when mounted on a mandrel and subjected to a cutting edge under a specified load using the Cut Protection Performance (CPP) Tester.
1.1.1 This procedure is not valid for high-porosity materials which allow cutting edge contact with the mounting surface prior to cutting.
1.1.2 Test apparatus may have limitations in testing materials with a thickness greater than 3 mm or having a high frictional coefficient such as elastomers.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.