BS EN 845-3:2013+A1:2016
Specification for ancillary components for masonry Bed joint reinforcement of steel meshwork
| Standard number: | BS EN 845-3:2013+A1:2016 |
| Pages: | 34 |
| Released: | 2016-09-30 |
| ISBN: | 978 0 580 84585 7 |
| Status: | Standard |
BS EN 845-3:2013+A1:2016
This standard BS EN 845-3:2013+A1:2016 Specification for ancillary components for masonry is classified in these ICS categories:
- 91.060.10 Walls. Partitions. Façades
- 91.080.30 Masonry
This European Standard specifies the requirements for masonry bed joint reinforcement for structural use (see
Where products are intended for use in cavity wall construction, this European Standard covers only the performance of the meshwork as reinforcement in bed joints and not its performance as wall ties across the cavity.
This European Standard is not applicable to:
-
products in the form of individual bars or rods;
-
products formed from materials other than specified grades of austenitic stainless steel, austenitic ferritic stainless steel, zinc pre-coated steel sheet or zinc coated steel wire with or without organic coating.
Annex ZA refers only to welded wire meshwork intended for structural use referred to in 5.2.1 as there are no known regulated requirements for products of this family for non-structural use.
Specification for ancillary components for masonry Wall ties, tension straps, hangers and brackets
Specification for ancillary components for masonry Lintels
Metal lath and beads. Definitions, requirements and test methods External rendering
Design, preparation and application of external rendering and internal plastering Internal plastering