Set DIN EN 13757 all parts- Communication systems for and remote reading of meters

Saving is € 100 compared to buying individual titles EN 13757- !  

• DIN EN 13757-1:2022 - Communication system for meters  - Part 1: Data Exchange - This document specifies data exchange and communications for meters in a generic way. This document establishes a protocol specification for the Application Layer for meters and establishes several protocols for meter communications which can be applied depending on the application being fulfilled. This document also specifies the overall structure of the Object Identification System (OBIS) and the mapping of all commonly used data items in metering equipment to their identification codes. NOTE Electricity meters are not covered by this document, as the standardization of remote readout of electricity meters is a task for CENELEC/IEC.
• DIN EN 13757-2:2024 - Communication systems for meters - Part 2: Wired M-Bus communication – This European standard is applicable to the physical and link layer parameters of baseband communication over twisted pair (M Bus) for meter communication systems. It is especially applicable to thermal energy meters, heat cost allocators, water meters and gas meters. NOTE It is usable also for other meters (like electricity meters) and for sensors and actuators. For generic descriptions concerning communication systems for meters and remote reading of meters see EN 13757-1.
• DIN EN 13757-3:2018 - Communication systems for meters - Part 3: Application protocols – This European Standard specifies application protocols for communication systems for meters and remote reading of meters. This draft European Standard specifies application protocols, especially the M-Bus application protocol. This draft European Standard is intended to be used with the lower layer specifications determined in EN 13757-2, EN 13757-4, EN 13757-5, EN 13757-6 and prEN 13757-7.
• DIN EN 13757-4:2019 - Communication systems for meters - Part 4: Wireless M-Bus communication - This European Standard specifies the requirements of parameters for the physical and the link layer for systems using radio to read remote meters. The primary focus is to use the Short Range Device (SRD) unlicensed telemetry bands. The standard encompasses systems for walk-by, drive-by and fixed installations. As a broad definition, this European Standard can be applied to various application layers.
• DIN EN 13757-5:2016 - Communication systems for meters - Part 5: Wireless M-Bus relaying - This European Standard specifies the protocols to use when performing relaying in wireless meter readout networks. This European Standard is an extension to wireless meter readout specified in EN 13757-4. It supports the routing of modes P and Q, and simple single-hop repeating of modes S, T, C, F and N. The main use of this standard is to support simple retransmission as well as routed wireless networks for the readout of meters. NOTE Electricity meters are not covered by this standard, as the standardisation of remote readout of electricity meters is a task for IEC/CENELEC.
• DIN EN 13757-7:2018 - Communication systems for meters - Part 7: Transport and security services – This European Standard specifies Transport and Security Services for communication systems for meters and remote reading of meters. This draft European Standard specifies secure communication capabilities by design and supports the building of a secure system architecture. This draft European standard is applicable to the protection of consumer data to ensure privacy. This draft European Standard is intended to be used with the lower layer specifications determined in EN 13757-2, EN 13757-3, EN 13757-4, EN 13757-5
• DIN EN 13757-8:2025 - Communication systems for meters - Part 8: Adaptation layer