PRICES include / exclude VAT
Homepage>ASTM Standards>77>77.140>77.140.01>ASTM A1010_A1010M-24 - Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet, and Strip
Sponsored link
Released: 01.03.2024

ASTM A1010_A1010M-24 - Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet, and Strip

Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet, and Strip

Format
Availability
Price and currency
English PDF Redline
Immediate download
70.62 USD
English PDF
Immediate download
58.86 USD
English Hardcopy
In stock
58.86 USD
Standard number:ASTM A1010_A1010M-24
Released:01.03.2024
Status:Active
Pages:3
Section:01.03
Keywords:architectural steel; martensitic; plate; stainless steel; steel; structural steel; tempered;
DESCRIPTION

1.1 This specification covers martensitic stainless steels for various structural, architectural, pressure vessel, and heat-resisting applications. The mechanical properties of these steels are customarily, but not necessarily, developed by a suitable heat treatment generally referred to as tempering.

1.2 Steel products under this specification are available in two grades:

Grade

Yield Strength, min, ksi [MPa]

40 [275]

40 [275]

50 [345]

50 [345]

1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness of plates furnished under this specification to 2 in. [50 mm].

1.4 This specification is expressed in both inch-pound units and in SI units; however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply. The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 Supplementary requirements are provided for use at the option of the purchaser. The supplementary requirements shall apply only when specified individually by the purchaser in the purchase order or contract.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.