ASTM C0125_C0125M-26A
Standard Terminology Relating to Concrete and Concrete Aggregates
| Standard number: | ASTM C0125_C0125M-26A |
| Released: | 01.04.2026 |
| Status: | Active |
| Pages: | 10 |
| Section: | 04.02 |
| Keywords: | aggregates; concrete; definitions; terminology; |
| ASTM number: | ASTM C125/C125M |
| Supersedes: | C0125-26 |
1.1 This standard is a compilation of definitions of terms as they are used in standards under the jurisdiction of Committee C09.
1.2 Other terminology under the jurisdiction of Committee C09 is included in two specialized standards. Terms relating to constituents of concrete aggregates are defined in Descriptive Nomenclature C294. Terms relating to constituents of aggregates for radiation-shielding concrete are defined in Descriptive Nomenclature C638.
1.3 Related terminology for hydraulic cement is included in Terminology C219. In the event of conflict between definitions in Terminology C125 and definitions in Terminology C219, definitions in Terminology C125 shall govern for Committee C09 standards.
1.4 When a term is used in an ASTM standard for which Committee C09 is responsible, it is included herein only if used in more than one Committee C09 standard.
Note 1: The subcommittee responsible for this standard will review definitions on a five-year basis to determine if the definition is still appropriate as stated. Revisions will be made when determined necessary. The year shown in parentheses at the end of a definition indicates the year the definition or revision to the definition was approved. A letter R and a year indicate when the definition was reviewed.
1.5 This terminology includes notes and discussions to definitions that provide supplementary or explanatory information. These notes and discussions shall not be considered as requirements of this standard nor as parts of the definitions.
1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.