Using Artificial Intelligence (AI) on standards and related intellectual property is strongly prohibited. In the event of a violation, your access to the standards will be revoked.
Main page>ASTM Standards>91>91.100>91.100.60>ASTM D0228_D0228M-21 - Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing
Released: 15.02.2021
ASTM D0228_D0228M-21
Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing
Format
Availability
Price and currency
English Secure PDF Redline
Immediate download
Non-printable
244.71 USD
English Secure PDF
Immediate download
Non-printable
221.18 USD
Standard number:
ASTM D0228_D0228M-21
Released:
15.02.2021
Status:
Active
Pages:
13
Section:
04.04
Keywords:
analysis; asphalt; cap sheets; composition; physical testing; roll roofing; sampling; shingles;
ASTM number:
ASTM D228/D228M
Supersedes:
D0228_D0228M-19A
DESCRIPTION
1.1 These test methods cover procedures for sampling, examination, physical testing, and analyses of asphalt-containing materials used in roofing and waterproofing. These materials include but are not limited to roll roofing, cap sheets, and shingles. Any of these materials is allowed to be partially or fully coated, surfaced, or laminated, or a combination thereof.
1.2 The test methods and procedures in this standard appear in the following order:
Section
Content
6
Types of Roofing
7
Sampling
8
Mass and Area Determination
9
Selection of Representative Specimens
10
Moisture
11
Pliability
12
Mass Loss and Behavior on Heating
13
Tear Strength
14
Fastener Pull-Through Resistance
15
Preparation and Selection of Small Test Specimens for Analyses
16
Analysis of Glass Felt Products
17
Analysis of Roofing Products with Organic Felts
18
Ash of Desaturated Felt
19
Calculation
20
Adjusting Back Coating Fine Mineral Matter and Back Surfacing
21
Report
22
Precision and Bias
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.