ASTM D0888-18
Standard Test Methods for Dissolved Oxygen in Water
| Standard number: | ASTM D0888-18 |
| Released: | 01.05.2018 |
| Status: | Active |
| Pages: | 14 |
| Section: | 11.01 |
| Keywords: | analysis; dissolved oxygen; frequency domain; lifetime-based; luminescence; probe; titrimetric; water ; |
| ASTM number: | ASTM D888 |
| Supersedes: | D0888-12E01 |
1.1 These test methods cover the determination of dissolved oxygen in water. Three test methods are given as follows:
|
| Range, mg/L | Sections |
| Test Method A—Titrimetric Procedure–High Level | >1.0 | 8 – 15 |
| Test Method B—Instrumental Probe Procedure—Electrochemical | 0.05 to 20 | 16 – 25 |
| Test Method C—Instrumental Probe Procedure—Luminescence-Based Sensor | 0.05 to 20 | 26 – 31 |
1.2 The precision of Test Methods A and B was carried out using a saturated sample of reagent water. It is the user's responsibility to ensure the validity of the test methods for waters of untested matrices.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statements, see 7.1 and Note 17.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Low-Level Dissolved Oxygen in Water