ASTM D1545-13R23
Standard Test Method for Viscosity of Transparent Liquids by Bubble Time Method
| Standard number: | ASTM D1545-13R23 |
| Released: | 01.07.2023 |
| Status: | Active |
| Pages: | 3 |
| Section: | 06.01 |
| Keywords: | Gardner-Holdt; GH viscosity; viscosity; |
| ASTM number: | ASTM D1545 |
| Supersedes: | D1545-13R17 |
This test method covers the procedures for determining the viscosity of transparent liquids by bubble time method. The transparent liquids should be free from crystalline or gel particles. Test apparatus include a constant-temperature bath, standard viscosity tubes, a series of standard viscosity tubes as reference standards, timing device, tube racks, and viscosity tube corks.
1.1 This test method covers the determination of the viscosity in bubble seconds by timing. The bubble seconds are approximately equal to stokes for most liquids.
1.2 The test method is applicable to transparent liquids that are free from crystalline or gel particles.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D0803-24 - Standard Test Methods for Testing Tall Oil
Standard Test Methods for Testing Tall Oil
ISO 4630:2015 - Clear liquids — Estimation of colour by the Gardner colour scale
Coil coated metals - Test methods - Part 5: Resistance to rapid deformation (impact test)
ISO 6270-2:2025 - Paints and varnishes — Determination of resistance to humidity — Part 2: Condensation (in-cabinet exposure with heated water reservoir)
ISO 2431:2019 - Paints and varnishes — Determination of flow time by use of flow cups