ASTM D3291-22 - Standard Practice for Compatibility of Plasticizers in Poly(Vinyl Chloride) Plastics Under Compression
Standard Practice for Compatibility of Plasticizers in Poly(Vinyl Chloride) Plastics Under Compression
| Standard number: | D3291-22 |
| Released: | 01.05.2022 |
| Status: | Active |
| Pages: | 3 |
| Section: | 08.02 |
| Keywords: | plasticizer compatibility; plasticizers; poly(vinyl chloride); |
1.1 This practice determines the compatibility of plasticizers in poly(vinyl chloride) plastics by rating the amount of plasticizer that spews due to compressional stress set up inside a 180° loop bend.
Note 1: Ingredients other than plasticizer can spew from a total formulation.
1.2 The text of this practice references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this practice.
1.3 The values as stated in SI units are to be regarded as the standard. The values in parentheses are given for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 2: There is no known ISO equivalent to this standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.