ASTM D7623-20

1.1 This test method covers the procedures to determine the total mercury content in a sample of crude oil.

1.2 The test method may be applied to crude oil samples containing between 5 ng/mL to 400 ng/mL of mercury. The results may be converted to mass basis, and reported as ng/g of mercury.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This work has been published in “Determination of Mercury in Crude Oil by Atomic Spectroscopy.”2

1.5 WARNING—Mercury has been designated by many regulatory agencies as a hazardous substance that can cause serious medical issues. Mercury, or its vapor, has been demonstrated to be hazardous to health and corrosive to materials. Use Caution when handling mercury and mercury-containing products. See the applicable product Safety Data Sheet (SDS) for additional information. The potential exists that selling mercury or mercury-containing products, or both, is prohibited by local or national law. Users must determine legality of sales in their location.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.