ASTM D7679-16R24
Standard Test Method for Sulfur Content in Carbon Black Feedstock Oils
| Standard number: | ASTM D7679-16R24 |
| Released: | 01.11.2024 |
| Status: | Active |
| Pages: | 5 |
| Section: | 09.01 |
| Keywords: | carbon black; combustion; feedstock; hydrocarbon oil; sulfur content; x-ray fluorescence; |
| ASTM number: | ASTM D7679 |
| Supersedes: | D7679-16R20 |
1.1 This test method covers the instrumental determination of sulfur content in samples of carbon black feedstock oils. Values obtained represent the total sulfur content. Two analysis methods are available for use:
| Test Method A: High-Temperature Combustion With | Sections 4 – 10 |
| Test Method B: X-Ray Fluorescence | Sections 13 – 17 |
1.2 This test method is applicable to carbon black feedstock oils derived from petroleum, coal, and other sources which include fuel oils, residues, tars, pitches, reclaimed oils, and similar materials that are normally handled as liquids. This test method is applicable to products typically containing 0 to 5 mass % sulfur.
1.3 The results of these tests can be expressed as mass % sulfur.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.