ASTM D7936-25
Standard Test Method for Flammability of Electrical Insulating Materials Intended for Wires or Cables When Burning in Horizontal Configuration
| Standard number: | ASTM D7936-25 |
| Released: | 01.12.2025 |
| Status: | Active |
| Pages: | 3 |
| Section: | 10.02 |
| Keywords: | cable; electrical insulating material; flame spread; flaming materials; horizontal flame spread; wire; |
| ASTM number: | ASTM D7936 |
| Supersedes: | D7936-20 |
1.1 This is a fire-test-response standard.
1.2 This fire test method is applicable to the electrical insulation materials contained in wires or cables.
1.3 The ignition source is a gas burner fueled by methane or natural gas.
1.4 Use the values stated in SI units in referee decisions; see IEEE/ASTM SI-10. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.5 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.
1.6 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.