PRICES include / exclude VAT
Homepage>ASTM Standards>ASTM D8263_D8263M-23 - Standard Test Method for Determining the Change in Mass of Rolled Erosion Control Products When Submerged in Water
Sponsored link
Released: 01.07.2023

ASTM D8263_D8263M-23 - Standard Test Method for Determining the Change in Mass of Rolled Erosion Control Products When Submerged in Water

Standard Test Method for Determining the Change in Mass of Rolled Erosion Control Products When Submerged in Water

Format
Availability
Price and currency
English PDF
Immediate download
67.41 USD
English Hardcopy
In stock
67.41 USD
Standard number:D8263_D8263M-23
Released:01.07.2023
Status:Active
Pages:5
Section:04.09
Keywords:mass; rolled erosion control product; RECP; submersion;
DESCRIPTION

1.1 This test method measures the change in mass of a rolled erosion control product when specimens are submerged in water for a prescribed period of time. The change in mass is reported as a percentage of the original dry mass of the specimen.

1.2 Units—The values stated in either SI units or inch-pound units [given in brackets] are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this standard.

1.2.1 It is common practice in the engineering/construction profession to concurrently use pounds to represent both a unit of mass (lbm) and of force (lbf). This practice implicitly combines two separate systems of units; that is, the absolute system and the gravitational system. It is scientifically undesirable to combine the use of two separate sets of inch-pound units within a single standard. As stated, this standard includes the gravitational system of inch-pound units and does not use/present the slug unit of mass. However, the use of balances and scales recording pounds of mass (lbf) or recording density in lbm/ft3 shall not be regarded as nonconformance with this standard.

1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026, unless superseded by this test method.

1.3.1 The procedures used to specify how data are collected/recorded and calculated in the standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of these test methods to consider significant digits used in analysis methods for engineering data.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.