ASTM E0738-20 - Standard Test Method for Determination of Aluminum in Iron Ores and Related Materials by EDTA Complexometric Titrimetry
Standard Test Method for Determination of Aluminum in Iron Ores and Related Materials by EDTA Complexometric Titrimetry
| Standard number: | E0738-20 |
| Released: | 01.07.2020 |
| Status: | Active |
| Pages: | 3 |
| Section: | 03.05 |
| Keywords: | agglomerates and related materials; aluminum content; concentrates; iron ores ; |
1.1 This test method2 covers the determination of aluminum in iron ores, concentrates, and agglomerates in the compositional range from 0.25 % to 5 % aluminum.
Note 1: As used in this test method (except as related to the term relative standard deviation), “percent” or “%” refers to mass fraction (mass/mass) of the form g/100 g.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.