ASTM E2485_E2485M-26
Standard Test Method for Freeze/Thaw Resistance of Exterior Insulation and Finish Systems (EIFS), EIFS with Drainage or a Water Resistive Barrier Coating
| Standard number: | ASTM E2485_E2485M-26 |
| Released: | 01.04.2026 |
| Status: | Active |
| Pages: | 3 |
| Section: | 04.12 |
| Keywords: | EIFS; EIFS with drainage; exterior insulation and finish systems; freeze/thaw resistance; water resistive barrier coating; |
| ASTM number: | ASTM E2485/E2485M |
| Supersedes: | E2485_E2485M-13R18 |
1.1 This test method covers procedures for determining the effect of freezing and thawing on exterior insulation and finish systems (EIFS), EIFS with drainage, or water-resistive barrier coating.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and to determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.