ASTM E3428-26
Standard Guide for Selecting and Using (Rapid) Sensory Characterization Methods
| Standard number: | ASTM E3428-26 |
| Released: | 01.08.2026 |
| Status: | Active |
| Pages: | 20 |
| Section: | 14.03 |
| Keywords: | alternative; characterisation; check-all-that-apply; descriptive; flash profiling; free choice profiling; hierarchical sorting; ideal profile; projective mapping; projective mapping/napping; rapid; ultra flash profile; |
| ASTM number: | ASTM E3428 |
| Supersedes: | E3428-25A |
1.1 The purpose of this guide is to discuss selecting and using methods that can be used to describe the sensory characteristics of products. It focuses specifically on the methods commonly referred to as rapid methods. This term will be used throughout this guide to describe these methods.
1.2 The requirements, strengths, and limitations for each rapid method are explained and the rationale for the selection of a specific rapid method is provided. Descriptive-based and similarity-based rapid methods are both presented in this guide.
1.3 Descriptive analysis (DA) is outside the scope of this guide; please refer to Ref (1) for guidance on this methodology.
1.4 This guide will not explain in detail the methodology associated with each specific sensory test method, although helpful references to existing publications are included.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.