PRICES include / exclude VAT
Homepage>BS Standards>81 GLASS AND CERAMICS INDUSTRIES>81.060 Ceramics>81.060.30 Advanced ceramics>BS EN 820-5:2009 Advanced technical ceramics. Thermomechanical properties of monolithic ceramics Determination of elastic moduli at elevated temperatures
Sponsored link
immediate downloadReleased: 2009-07-31
BS EN 820-5:2009 Advanced technical ceramics. Thermomechanical properties of monolithic ceramics Determination of elastic moduli at elevated temperatures

BS EN 820-5:2009

Advanced technical ceramics. Thermomechanical properties of monolithic ceramics Determination of elastic moduli at elevated temperatures

Format
Availability
Price and currency
English Secure PDF
Immediate download
277.33 USD
You can read the standard for 1 hour. More information in the category: E-reading
Reading the standard
for 1 hour
27.73 USD
You can read the standard for 24 hours. More information in the category: E-reading
Reading the standard
for 24 hours
83.20 USD
English Hardcopy
In stock
277.33 USD
Standard number:BS EN 820-5:2009
Pages:28
Released:2009-07-31
ISBN:978 0 580 63846 6
Status:Standard
DESCRIPTION

BS EN 820-5:2009


This standard BS EN 820-5:2009 Advanced technical ceramics. Thermomechanical properties of monolithic ceramics is classified in these ICS categories:
  • 81.060.30 Advanced ceramics
This part of EN 820 describes methods for determining the elastic moduli, specifically Young's modulus, shear modulus and Poisson's ratio, of advanced monolithic technical ceramics at temperatures above room temperature. The standard prescribes three alternative methods for determining some or all of these three parameters: A the determination of Young's modulus by static flexure of a thin beam in three- or four-point bending. B the determination of Young's modulus by forced longitudinal resonance, or Young's modulus, shear modulus and Poisson's ratio by forced flexural and torsional resonance, of a thin beam. C the determination of Young's modulus from the fundamental natural frequency of a struck bar (impulse excitation method). This part of EN 820 extends the above-defined room-temperature methods described in EN 843-2 to elevated temperatures. All the test methods assume the use of homogeneous test pieces of linear elastic materials. The test assumes that the test piece has isotropic elastic properties. At high porosity levels all of the methods can become inappropriate. The maximum grain size (see EN 623-3), excluding deliberately added whiskers, should be less than 10 % of the minimum dimension of the test piece. NOTE 1 Method C in EN 843-2 based on ultrasonic time of flight measurement has not been incorporated into this part of EN 820. Although the method is feasible to apply, it is specialised, and outside the capabilities of most laboratories. There are also severe restrictions on test piece geometries and methods of achieving pulse transmission. For these reasons this method has not been included in EN 820-5. NOTE 2 The upper temperature limit for this test depends on the properties of the test pieces, and can be limited by softening within the timescale of the test. In addition, for method A there can be limits defined by the choice of test jig construction materials.