PRICES include / exclude VAT
Homepage>BS Standards>31 ELECTRONICS>31.220 Electromechanical components for electronic and telecommunications equipment>31.220.01 Electromechanical components in general>BS EN IEC 60603-7:2020 Connectors for electronic equipment Detail specification for 8-way, unshielded, free and fixed connectors
Sponsored link
immediate downloadReleased: 2020-11-26
BS EN IEC 60603-7:2020 Connectors for electronic equipment Detail specification for 8-way, unshielded, free and fixed connectors

BS EN IEC 60603-7:2020

Connectors for electronic equipment Detail specification for 8-way, unshielded, free and fixed connectors

Format
Availability
Price and currency
English Secure PDF
Immediate download
377.00 USD
English Hardcopy
In stock
377.00 USD
Standard number:BS EN IEC 60603-7:2020
Pages:60
Released:2020-11-26
ISBN:978 0 539 03483 7
Status:Standard
DESCRIPTION

BS EN IEC 60603-7:2020


This standard BS EN IEC 60603-7:2020 Connectors for electronic equipment is classified in these ICS categories:
  • 31.220.10 Plug-and-socket devices. Connectors
  • 31.220.01 Electromechanical components in general
IEC 60603-7:2020 is available as IEC 60603-7:2020 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.

IEC 60603-7:2020 covers 8-way, unshielded, free and fixed connectors and is intended to specify the common dimensions (interface dimensions), mechanical, electrical and environmental characteristics and tests for the family of IEC 60603-7-x connectors. These connectors are intermateable (according to IEC 61076-1 level 2) and interoperable with other IEC 60603-7 series connectors. This fourth edition cancels and replaces the third edition, published in 2008, its Amendment 1:2011 and its Amendment 2:2019. It constitutes a technical revision. This edition includes the following significant technical change with respect to the previous edition:
- Revised the definitions for intermateability and interoperability; added new definitions.
- Corrected dimension line for dimension AZ2 in Figure 5.
- Corrected dimension line for dimension F1 in Figure A.1.
- Revised the reference to ISO/IEC 11801 to ISO/IEC 11801-1.
- Added lower limiting temperature and upper limiting temperature definitions.
- Revised Table 1 to Table 8 so the column order is Minimum-Nominal-Maximum dimensions (ascending order).
- Corrected Table 7: Climatic category and Upper temperature values to 90 °C (to be consistent with the graph in Figure 10 and Note 1 in Figure 10).
- Revised the wording in 8.2, contact resistance, for clarification.
- Revised Figure 11 and Figure 12 and the wording in the Key below for clarification.
- Removed the sentences under the figure in the Introduction.
- Added Annex E.