BS EN 17886. Laboratory test method. assessment of the susceptibility of thermal insulation products to mould growth
CURRENCY
Standard number:
22/30455532 DC
Pages:
21
Released:
2022-07-28
Status:
Draft for Comment
DESCRIPTION
22/30455532 DC
This standard 22/30455532 DC BS EN 17886. Laboratory test method. assessment of the susceptibility of thermal insulation products to mould growth is classified in these ICS categories:
91.120.10 Thermal insulation of buildings
This document describes a laboratory test method to determine the susceptibility of thermal insulation products used for construction against mould growth under specified climatic conditions. The method is applicable to both factory-made products and in situ formed products. Factory-made products include panels, mats, and rolls. In situ formed products are usually those that are delivered loose and installed by blowing-in, poring, or spraying-on, using water and/or binder, whether or not they are also treated using additives. Depending on the insulation manufacturer, the test is carried out with one of the conditions in Table 1. This condition is linked to worst case scenarios selected from real hygrothermal conditions that reflect the end use conditions experienced by insulation products, and to short test duration for mould test. This test method determines the susceptibility of a thermal insulation material to mould growth, but does not determine the suitability for use in a given design (wall, roof, etc.). This method does not predict the resistance of an insulation product to accidental water exposure resulting in saturation of the product (water damage).