PRICES include / exclude VAT
Homepage>ASTM Standards>ASTM A0956_A0956M-17A - Standard Test Method for Leeb Hardness Testing of Steel Products
Not available online - contact us!
Released: 2020-03-31

ASTM A0956_A0956M-17A

Standard Test Method for Leeb Hardness Testing of Steel Products

CURRENCY
67.77 USD
Language:English
Released:2020-03-31
Pages:14
Standards number:ASTM A0956_A0956M-17A
Standard number:A0956_A0956M-17A
Released:01.11.2017
Status:Active
Pages:14
Section:01.03
Keywords:dynamic hardness test; Equotip; Equotip hardness test; Leeb; rebound hardness test;
DESCRIPTION

1.1 This test method covers the determination of the Leeb hardness of steel, cast steel, and cast iron (Part A), including the methods for the verification of Leeb hardness testing instruments (Part B), and the calibration of standardized test blocks (Part C).

Note 1: The original title of this standard was “Standard Test Method for Equotip Hardness Testing of Steel Products.”1

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.